Acustic Paneele Shelf holder
The shelf holder is available in three sizes (S,M,L) and can carry 8 kg (17,64 lbs).
The recommended shelf depth for set S is 10 cm (3,94 inch), for set M is 15 cm (5,91 inch) and for set L is 20 cm (7,87 inch).
Manufactuaring
The acustic panel shelf holder are made using 3D printing technology from environmetally friendly and biogradeable PLA.
Installation
The shelf holder are provided for standart acustic panels (Bauhaus, Hellweg, Fibrotec ect) with slat depth of 13 mm (0,51 inch) mm and 13 mm - 16 mm (0,51 inch - 0,63 inch) between the slats.
The hooks can be easily assembled with a 5,5 mm (0,22 inch) screwdriver. The holders are hung in the holders. Finally mount the cover. No drilling is necassary.
The holder can be disasembled and placed to another position.
Please note: This article is designed for wooden slats with a felt base, that are each other connected with clamps. If the the slats and feld are glued, the hook may not be installed as intended.
If the hook can not be installed or is difficult to install, a clamp is hindering the installtion. In this case, try another postion a little bit higher or deeper. Avoid to much force during installation.
Included in delivery
A set consits of:
- Two hooks
- Two cover
- Two holder S,M or L
The shelf and the decoration is not included.
