Acustic Panel holder
The acustic panel holder can be used for hang up pictures.
It can carry 2 kg (4,41 lbs).
Manufactuaring
The acustic panel shelf holder are made using 3D printing technology from environmetally friendly and biogradeable PLA.
Installation
The shelf holder are provided for standart acustic panels (Bauhaus, Hellweg, Fibrotec ect) with slat depth of 13 mm (0,51 inch) mm and 13 mm - 16 mm (0,51 inch - 0,63 inch) between the slats.
The hooks can be easily assembled with a 5,5 mm (0,22 inch) screwdriver. Srews and hooks can be screwed in, to hang up a picture, for example. The holder can be disasembled and placed to another position.
Please note: This article is designed for wooden slats with a felt base, that are each other connected with clamps. If the the slats and feld are glued, the hook may not be installed as intended.
If the hook can not be installed or is difficult to install, a clamp is hindering the installtion. In this case, try another postion a little bit higher or deeper. Avoid to much force during installation.
Included in delivery
One holder, or optionally a set with five of ten pieces.
There are no screws, hooks or the picture included.
